Junction Box Category 6
PLANET PL-JBR61 is a Category 6 junction box for direct cable-to-cable connection using punch-down IDC termination. It is intended to join, repair or extend two four-pair balanced copper cables without adding an RJ45 plug-to-jack interface. The supplied product image shows a shielded metal enclosure and PCB-based feed-through construction.
The supplied source specifies Category 5e/6 (or lower) cable support, dual-type IDC punch-down terminals, cable-tie retention, double-sided tape or screw mounting, and PCB construction for reliability. Category 6 / 250 MHz performance is presented as the intended system performance and depends on correct termination and the complete installed channel.
| Parameter | Specification |
| Category / Frequency | Category 6 / up to 250 MHz (marking visible on supplied product) |
| Supported Cabling | Category 5e / Category 6 and lower balanced copper cabling, as stated in the supplied source |
| Termination Type | Dual-type IDC punch-down terminals |
| Connection Type | Direct cable-to-cable feed-through; no RJ45 mating interface |
| Internal Architecture | PCB feed-through interconnect |
| Housing Configuration | Shielded metal enclosure shown; the supplied source also mentions shielded and unshielded configurations |
| Strain Relief | Cable tie provision / cable retention |
| Mounting | Double-sided adhesive tape or screw mounting, as stated in the supplied source |
| Pairs / Conductors | 4 pairs / 8 conductors per connected cable |
| Standards Reference | ANSI/TIA-568.2-E and ISO/IEC 11801-1 as system-level Category 6 / Class E design references |
